what are these from?
4 posts
• Page 1 of 1
what are these from?
by ausedwagon » July 13th, 2012, 2:45 pm
after pulling the head off the ed after it stopped some of the pistons have clean spots, any ideas?
Ausedwagons... wagon http://www.boostedfalcon.net/viewtopic.php?f=3&t=16097
-
ausedwagon - Spooling Up
- Posts: 691
- Joined: June 25th, 2009, 10:22 am
- Location: mooroolbark
- Has Liked: 14 times
- Been Liked: 25 times
1994 Ford Falcon
Re: what are these from?
by JUZXR8 » July 13th, 2012, 2:49 pm
Just carbon buildup mate. Pretty sure its just from running rich or using oil, maybe a mix of the two?
Rollin wrote:Were you heavily into ice when you bought them?
-
JUZXR8 - Cruising
- Posts: 299
- Joined: August 4th, 2007, 11:32 am
- Has Liked: 14 times
- Been Liked: 19 times
Re: what are these from?
by misk » July 13th, 2012, 4:00 pm
did you blow a head gasket?
thats usually a sign of water getting into the cylinder over a long period of time
thats usually a sign of water getting into the cylinder over a long period of time
XG Panelvan
EF bottom end with ported EB head, valve springs, EL ECU & J3 chip, crane HI6 CDI & MSD coil, LC-1 wideband & SSI-4 logger
soon - .595" lift cam, GT4202, forged AU engine and built head, ems stinger 4424 ecu, powerglide with 5500 high stall etc - next, bellhousing
XH ute daily - DOHC BA XR6 engine, T5, AU3 ECU with TI J3 chip, ported BBM, 3" stainless intake - 12" sub, tub liner and hard lid - mass skids and epic tyre carrying capabilities
EF bottom end with ported EB head, valve springs, EL ECU & J3 chip, crane HI6 CDI & MSD coil, LC-1 wideband & SSI-4 logger
soon - .595" lift cam, GT4202, forged AU engine and built head, ems stinger 4424 ecu, powerglide with 5500 high stall etc - next, bellhousing
XH ute daily - DOHC BA XR6 engine, T5, AU3 ECU with TI J3 chip, ported BBM, 3" stainless intake - 12" sub, tub liner and hard lid - mass skids and epic tyre carrying capabilities
-
misk - Melting Pistons
- Posts: 10047
- Joined: October 14th, 2008, 10:31 am
- Location: dandenong
- Has Liked: 298 times
- Been Liked: 295 times
Re: what are these from?
by ausedwagon » July 13th, 2012, 4:03 pm
misk wrote:did you blow a head gasket?
thats usually a sign of water getting into the cylinder over a long period of time
no water in the oil, car just stopped and when i tried to start it it backfired and farted but wouldn't run.
Ausedwagons... wagon http://www.boostedfalcon.net/viewtopic.php?f=3&t=16097
-
ausedwagon - Spooling Up
- Posts: 691
- Joined: June 25th, 2009, 10:22 am
- Location: mooroolbark
- Has Liked: 14 times
- Been Liked: 25 times
1994 Ford Falcon
4 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users