Ef falcon holding revs after I cleaned the throttle body

[TUFEF6]

Hi Guys I am new to the boosted falcon site just need some help today I cleaned my throttle body on my car and serviced completely and once I put back the throttle body on it was holding revs when I stabbed on the accelerator and all the sensors are back on it and the breather pipe but when I take the valve sensor off it stops holding revs and idles great don't know what has happened if anyone can help that would be great cheers

[Turbo XR6]

what car?
What model?
What is it I6 or V8?
Manual or Auto?
What valve sensor?
Is it chipped?
Standard?

Make it easier for people to reply if they Know more about it to start off with.

Cheers

[Chargd]

ive got a bit of rev hang with my car and been told to adjust the throttle sensor, maybe this is your issue.

[Rollin]

Depends on what is going on as to why it might be holding too many revs.

If the throttle body was full of crap someone may have adjusted the base idle (via the set screw) to make it idle normally rather than too low.

If that's the case you'll need to back the set screw off slightly to get the car to idle normally with the idle control motor plugged in (there is a proper procedure for this, buy a gregories manual or google it).

If it's idling high because you've forgotten to put something on and now have a vacuum leak, put the thing back on so it idles normally.

The computer may also have 'learned' that the throttle body was full of crap and has been compensating, in which case it will probably settle down after a few days of driving, and the computer 'learns' that the throttle body is flowing plenty of air.

If it's an EA-ED and you have put the idle control motor on the the throttle body facing the wrong way it will idle high as well. Not sure if the same happens on EF-AU.

[TUFEF6]

Sorry guys its a Ef falcon 1996 series 2 v6 manual with full exhaust cam and supposedly tuned but it needs another tune all hoses and sensors are plugged on

[Turbo XR6]

I6 it will be not a V6..

[-fairmont-]

Turbo XR6, You sure? I've seen a few V6 falcons pop-up on ebay haha

[TUFED6]

Jeez did you bite my plates much bro??

[thebeast.]

re clean the TB again, i cleaned it with some nulon foaming TB cleaner which i was told was good, after that the revs would hang for a while, few weeks later i cleaned it out again with the three bond stuff and it completely got rid of the problem. what did you use to clean it out and how did u clean it?