Boosted Falcon

hey guys,

looking at keeping the XR now after yesterday mornings events and im loking at fitting EL XR6 front and back seats and door trims into my EB. I was just wondering whats involved in doing this. It looks like the front seats have the same bottom rails, but what about the rears?
i also know that to fit the trims on you have to bend the door lever or something? whats the go there?



these are the seats-----> http://www.fordforums.com.au/showthread.php?t=11197855

yes i know they are from FF, but i like the seats

cheers

Back seats slip straight in, and the back rests will bolt up fine except for the catch pin that clicks them into the upright position (i just took my pins out to save the hassle). Front seats are a bit more tricky, the rear inner seat mounts are about 2-3 inches higher off the floor than the EB mounting point, so you will either haveto slip in a spacer to make up the difference or weld in a section of the bracket used on the EF/EL floors. I have also heard of people swapping over the rails on the seats but have not personaly done this so i dont really know.

what about the rear bolsters?

EF/L rear seat side bolsters will fit fine, its Fairlane ones that are larger

What happened at yesterday mornings events? Spill the beans

haha...my sister was ina car accident n got her car written off, so she is gonna take mums car, dads gonna take mums n my dad is gonna drive mine until i get my licence back. Mind you i still have to goto court yet so i might not even lose my licence

Sheesh tough break! Hope your sisters ok. Hopefully all goes your way at court!

yeah she is ok, just whiplash and a bit of bruising.

what is the g.o. with the handles though? i put the back seats in no probs, the fronts ill tackle on friday, but the handle mechanism isn't right. Do i need to get ones from EL doors?