Conversions for XR8 AU series II Ute
2 posts
• Page 1 of 1
Conversions for XR8 AU series II Ute
by Roddy217 » April 15th, 2011, 8:21 pm
What 9" diff will bolt straight onto my ute it's an XR8 AU Series II ute (manual)
- Roddy217
- Cranking Over
- Posts: 1
- Joined: April 15th, 2011, 8:11 pm
- Has Liked: 0 time
- Been Liked: 0 time
Re: Conversions for XR8 AU series II Ute
by justa6 » April 17th, 2011, 12:44 pm
i don't think any do. you take your diff out, have your axle tube's put into a 9" 28spline centre. not that expensive for a diff shop to do, around $500 i think. it's expensive if you want bigger axle's or tru-track centre etc. driveline section may of been the go for this.
manley rods, sps pistons, billet surecam, gt4202r 1.15, 6boost manifold, 60mm gate, 4" exhaust, nizpro plenum, 80mm throttle body, bosch 2000cc injectors, 2x044, -8 fuel line, standard fuel rail modified -8 in-out. c4 box 3000 stall, standard diff with 31 spline axles, full spool.
477rwkw 24psi. 9.80 @ 145mph
-
justa6 - Full Boost
- Posts: 2986
- Joined: February 24th, 2008, 2:55 pm
- Has Liked: 88 times
- Been Liked: 525 times
1999 Ford xr6 ute
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users