Boosted Falcon • View topic - 4.1 pistons into a 4l

4.1 pistons into a 4l

4 posts • Page 1 of 1

4.1 pistons into a 4l

by raa4.0L » September 6th, 2012, 11:57 pm

Has anybody tried 4.1 xflow flat tops into an eseries motor?
I searched but could not find any answers.

Check this out for a cool ford!
http://myweb.westnet.com.au/meanstreak/

raa4.0L: Spooling Up; Posts: 677; Joined: August 9th, 2007, 9:34 am; Location: Dalby QLD; Has Liked: 31 times; Been Liked: 17 times

Re: 4.1 pistons into a 4l

by misk » September 7th, 2012, 12:03 am

what would you be trying to achieve with the build?

XG Panelvan
EF bottom end with ported EB head, valve springs, EL ECU & J3 chip, crane HI6 CDI & MSD coil, LC-1 wideband & SSI-4 logger

soon - .595" lift cam, GT4202, forged AU engine and built head, ems stinger 4424 ecu, powerglide with 5500 high stall etc - next, bellhousing

XH ute daily - DOHC BA XR6 engine, T5, AU3 ECU with TI J3 chip, ported BBM, 3" stainless intake - 12" sub, tub liner and hard lid - mass skids and epic tyre carrying capabilities

misk: Melting Pistons; Posts: 10047; Joined: October 14th, 2008, 10:31 am; Location: dandenong; Has Liked: 298 times; Been Liked: 295 times

Re: 4.1 pistons into a 4l

by raa4.0L » September 7th, 2012, 12:06 am

Big comp ie 0 cc dish lol

Check this out for a cool ford!
http://myweb.westnet.com.au/meanstreak/

raa4.0L: Spooling Up; Posts: 677; Joined: August 9th, 2007, 9:34 am; Location: Dalby QLD; Has Liked: 31 times; Been Liked: 17 times

Re: 4.1 pistons into a 4l

by raa4.0L » September 8th, 2012, 8:13 pm

So nobody has any ideas if this will work?

Check this out for a cool ford!
http://myweb.westnet.com.au/meanstreak/

raa4.0L: Spooling Up; Posts: 677; Joined: August 9th, 2007, 9:34 am; Location: Dalby QLD; Has Liked: 31 times; Been Liked: 17 times

4 posts • Page 1 of 1

Return to General Discussion

Who is online

Users browsing this forum: No registered users