willing to pay a small hire fee if required
dialing in a cam, s.e melb
1 post
• Page 1 of 1
dialing in a cam, s.e melb
by misk » October 12th, 2012, 2:15 am
just wondering if anyone has the tools to dial in a camshaft in s.e. melb?
willing to pay a small hire fee if required
willing to pay a small hire fee if required
XG Panelvan
EF bottom end with ported EB head, valve springs, EL ECU & J3 chip, crane HI6 CDI & MSD coil, LC-1 wideband & SSI-4 logger
soon - .595" lift cam, GT4202, forged AU engine and built head, ems stinger 4424 ecu, powerglide with 5500 high stall etc - next, bellhousing
XH ute daily - DOHC BA XR6 engine, T5, AU3 ECU with TI J3 chip, ported BBM, 3" stainless intake - 12" sub, tub liner and hard lid - mass skids and epic tyre carrying capabilities
EF bottom end with ported EB head, valve springs, EL ECU & J3 chip, crane HI6 CDI & MSD coil, LC-1 wideband & SSI-4 logger
soon - .595" lift cam, GT4202, forged AU engine and built head, ems stinger 4424 ecu, powerglide with 5500 high stall etc - next, bellhousing
XH ute daily - DOHC BA XR6 engine, T5, AU3 ECU with TI J3 chip, ported BBM, 3" stainless intake - 12" sub, tub liner and hard lid - mass skids and epic tyre carrying capabilities
-
misk - Melting Pistons
- Posts: 10047
- Joined: October 14th, 2008, 10:31 am
- Location: dandenong
- Has Liked: 298 times
- Been Liked: 295 times
1 post
• Page 1 of 1
Who is online
Users browsing this forum: No registered users