need some advice

[crossbred-xf]

Hi all i am currently doin up an xf ute it is a bare shell i am planning on putting an ef fairmont dash board in it just wondering if any1 else has done this before if so i would like a few pointers please

[TAXI]

If you were using the engine and gearbox from the ef it would be easy.
You would just trial fit dash cut and make new mounting brackets, and lay a complete wiring the loom in.
But trying to do it using the crossflow it wouldn't be easy getting the cluster working without the ef loom.

[crossbred-xf]

I am running the 4 litre but i want to run the el motor isit a hard job to wire the el engine loom into a ef main loom???? would really like to put a ba xr6t motor in it but can't afford to atm lol