Boosted Falcon

Gday again
Any tips how to fit the condenser between the radiator and intercooler and does the standard radiator handle the turbo
] Cheers Dave

What's going on out surly someone has some advice

Depends on how big your intercooler is for any issues with the radiator.

I'm deciding on either a 480x300 or 600x300. I don't see the condenser being an issue, however the receiver/drier will need to be relocated, and also new A/C lines made up.


Sent from my iPhone using Tapatalk

I have a 600 x 300 as far forward as can go on AU with front support and the pipes on the Condensor rap around in between causing the problem may have try and cut them and run them from the end ???

I had to take a little off the webbing of the bar at the front, just on the outside edges of the cooler. Then the cooler could move forward as far as possible.

I've had the standard radiator for years.

Thanks for that did your engineer have anything to say about that

If you do it neat, it looks fine.

Yeah my engineer loves my Ute.

All good then hope mine has the same affect and thanks for help

Marty you being the engineer

R so that's how it works is that love for sale or just self gratification

Depends, have you got big tits and tight arse Haha.

Na Mine's not engineered mate. Should do it, just haven't been bothered for how much I drive it on the road.

Might get someone with big tits and a tight arse to take it to the engineer

I like your thinking.