hey guys. just need someone to do me a favour.
my pedal box tore through where the malwood pin goes through.
im at work making up a plate to go on there. i just need somone to quickly go out and measure the distance between the hole the pin goes through. and the lip of the box. on the inside.
urgent. need measurement
2 posts
• Page 1 of 1
urgent. need measurement
by holmsy » October 6th, 2008, 6:52 am
Project: SLOXR8: 1994 EF XR8, mech shift kit, 3500 histall, Lokka, 36lb injectors, AU 185 motor, Cranecam 444225, crane roller rockers, crow valve springs, Pacies, 3" exhaust, hiflo cats. twin 044's, vortech v2,microtech tuned by daltons (290.3rwkw @11psi) at DALTONS
-
holmsy - Shooting Flames
- Posts: 6473
- Joined: August 2nd, 2007, 11:07 pm
- Location: Geelong
- Has Liked: 182 times
- Been Liked: 154 times
1994 Ford XR8
Re: urgent. need measurement
by holmsy » October 6th, 2008, 3:33 pm
you people are useless 
i just guessed and lucky me i was close enough to right
car is going again
i just guessed and lucky me i was close enough to right
car is going again
Project: SLOXR8: 1994 EF XR8, mech shift kit, 3500 histall, Lokka, 36lb injectors, AU 185 motor, Cranecam 444225, crane roller rockers, crow valve springs, Pacies, 3" exhaust, hiflo cats. twin 044's, vortech v2,microtech tuned by daltons (290.3rwkw @11psi) at DALTONS
-
holmsy - Shooting Flames
- Posts: 6473
- Joined: August 2nd, 2007, 11:07 pm
- Location: Geelong
- Has Liked: 182 times
- Been Liked: 154 times
1994 Ford XR8
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users