Boosted Falcon

I took my car to ringwood performance exhaust a couple of weeks ago to get a redback tailpipe with no muffler and hi flow cat put on my falcon.
Cost me $345 to get this done and what they done was cut the muffler out of a normal redback pipe and welded a bit of press bent pipe on. I was unhappy so i took it back and they fixed it up.

The car started making a sound like the exhaust had a leak in it. so today i pulled the cat out to find they have missed 3 spots when welding. I'm pissed off
one of the spots is atleast 4mm wide and 3mm deep.

They will be getting a call tomorrow morning.

The point behind this post is. Dont use RINGWOOD PERFORMANCE EXHAUST they are fu(king shit and do shit work.

Gee I hope they dont read this before you call them tomorrow. I'm fairly sure one of the boys visits this site.

i hope they do. so they realise they need to pick up their quality of work or there going to start loosing customers.

Its Ringwood, what do you expect....lol

Whats wrong with Ringwood?

Go to carline

thats a pretty piss poor effort.. a tailpipe costs like $70, and easy to fit.. slack fuckers!

I have used this place heaps of time and have had no problems with there work, i found there prices and quality of work to be very good!

Well i went there this morning and they welded up the holes. They also welded up 2 cracks that were also in my exhaust which i was happy with. As far as i am concerned i will not be going back there again.

Each to their own.

I am very fussy and if a job is done with a simple mistake, I will not got back or refer anyone there.

^^ im the same if its not quite to my standard or not ready when they say it will be i wont go back, had that trouble when i had my extractors put on, dropped the car off at 8 in the morning, and as i was round the area drove past it once or twice and it hadnt even bin moved till at least 2 pm, they said early arvo when it was done. didnt get it back til 530, wasnt very happy.

They should be letting jobs out, in a form they would be happy to recieve them in. Sounds very poor quality work if they leave it in that condition for the customers