Boosted Falcon

hey im doug im 17 and on my ls im from mackay and i own the ef falcon


MODS:


wildcat extractors and 2 and half inch exhuast system

ss inductions cold air intake

lowerd on lovells springs

pioneeer cd player and rapage amp and sub

17 in rodney janes

Looks nice mate,Would be perfect if it was abit lower
Any plans?

Very nice!

im gunna get and lsd (needs 1 bad ) mabye a cam and a j3 and tune and get the ford logo stiched into hood lining but apart fro that just im gunna injoy the car then after i get of my ls and p plates im gunna raptorcharge it

not bad at all mate, where were those pics taken, i havent seen that around town yet

pic were taken and my grand parents at st hellens but u will see this car drive from paget to walkerston most week days or driving around mackay on week ends

i took the car 2 to the plamyra drag on the weekend it ran a 16.1 at 86mph with just intake and extrators and 2 and half inch exhust system and a bog stock motor and ecu how ever i was abit iterested in how much it would take to make it at least a 14 sec car so im doing more mods mainly power 1s so within the next mounth or 2 im getting a stally and also a and a ported head and mild cam and vernier cam gear and j3 chip also getting the 180kmph speed limiter removed ill keeep use guys updated as time goes by

you better think about upgrading your tail shaft if you are going to take the car over 180km/h.
nice car by the way looks very clean.

Tailshaft isn't the drama, it's the extention housing on the box. If you want 14's, manual it.

yeah at were i work they can build me a stronger tailshaft 67rce what happens to the extension housing and does that happen with like with the auto or manaul

yeah no point removing it as you will just end up killing yourself.

also there is a heap more better ways to get the power from the motor then a raptor kit. especially now days.

im picking up a AIT turbo kit, good for over 250rwkw (been proven) and a 2nd hand intercooler piping. in total with upgraded fuel pump and new ebay intercooler less then 2k.

sure it might not be the best out there but as a starter kit it will produce more power then the raptor kit and cost less then half the cost of the raptor kit.

but if your dead set on supercharger have a look at the snort performance M112 supercharger kit. bolts straight onto the side of the head and looks tough

i cant boost it yet im still on my ls ):

turbo_nut wrote:yeah at were i work they can build me a stronger tailshaft 67rce what happens to the extension housing and does that happen with like with the auto or manaul

The extention housing shatters, letting the tailshaft cause carnage

yeah i know huggiebear, mate asked me same thing i just put them in there coz i have a pioneerhead unit and also stop boot getting dirty btw do they look boganish? if so ill take em out

everything pioneer is boganish

no one looks in boots anyways. so if they serve a purpose just leave them in there

btw how u think the cars comming along huggiebear, ?

looks nice, i love the colour and the wheels. one thing i would do, i know its only a GLi and always will be, but find a futura or fairmont dash spear and change it over, the mint green just doesnt look good.

here is the one i got in my NC Fairlane


i now have a fairmont one in there but cant find the pic

yeah i ill do that can u get a tickford one?

Adypie wrote:you can get an xr6 one. but it'll always be a lie. the whole act of changing badges is a fail.

if you hate the green, just paint the whole dash spear or some shit.

Just as fail as putting wheels off another model onto yours...... Basically you've called Rollin's ED a Fail, It's a GLi, with ED XR6 Badging, ED XR front, ED XR interior and a fuckload more power, where is teh fail there?

OMG I LOVE ROLLIN SO MUCH!!!

My car has parts from so many different cars on it I should apply to QLD transport for an individually constructed vehicle registration!

Getting back on topic, the reason the extension housing on the box could let go is because the tailshaft isn't perfectly balanced from factory and at high speeds can develop a 'whipping' motion similar to what a skipping rope does when you have a person on each end.

If you get the shaft balanced really well you shouldn't have any problems, but fitting a tailshaft loop would be a good idea also.

We have this rule here.

Its called dont be a dickhead.

Everyone who posted arguing about floor mats, subs and badging is banned. Get a fucken life.

Thread cleaned.

have my posts been ok?