Page 1 of 1
HI guys from a newb. building a eb xr6 turbo single cam
Posted:
July 27th, 2012, 4:43 pmby badvl
Hi everyone im new to the 4ltr scene and im going to have a go at building a single cam turbo on gas from what i can gather so far I will be using a low kms au engine I have a set of bf gas conrods and in the process of geting a std set of xr6t pistons im going to fly cut them .I also have a jd custom cast plenum (looks awsome) jd is also in the proses of making me a exhaust manifold to suit a china t04z it will run gas reserch throttle body with a ignition only computer .if any one has any other proven ideas for any other engine / head combos let me no thanks guys
Re: HI guys from a newb. building a eb xr6 turbo single cam
Posted:
July 27th, 2012, 5:20 pmby Michael (HYPOEB)
Sounds good mate. Should put the photos up
Re: HI guys from a newb. building a eb xr6 turbo single cam
Posted:
July 27th, 2012, 8:38 pmby misk
You can't use xr6t pistons on e-gas as the condos have a press fit gudgeon pin and the pistons are full floating design.
Best.bet is to get some Bf 06/06 or newer turbo conrods.as they are the stronger rods. basically same as e-gas.except the gudgeon pin design
Re: HI guys from a newb. building a eb xr6 turbo single cam
Posted:
July 27th, 2012, 9:11 pmby badvl
thanks for that good to no every one i spoke to sed they are the same
Re: HI guys from a newb. building a eb xr6 turbo single cam
Posted:
September 3rd, 2012, 12:37 pmby mattb347
i have done one of these only recently and am supervising another one being built.
theres a lot of technical stuff you have to get right to make the GRA system work with pressurised LPG supply and ignition timing, also head sealing is critical, a top end stud kit will help.
let me know when you run into trouble, i am happy to share what i know.