G6ET drags

Car Setups, Photos, Discussions

G6ET drags

Postby g6ej3t » October 5th, 2014, 12:20 pm

Hey guys, i have a g6e turbo with 320rwkw. i took it to the drags and got a best time of 12.2 launching @ 1,500RPM.
I was afraid to go any higher incase i twist my tailshaft. im going to get mine upgraded, but i was wondering if theres anything that would be likely
to give up if i launch under boost?
g6ej3t
Cranking Over
 
Posts: 1
Joined: October 5th, 2014, 12:12 pm
Has Liked: 0 time
Been Liked: 0 time

Re: G6ET drags

Postby justa6 » October 6th, 2014, 11:52 am

On street tyres I'm sure you would be fine.
Image
manley rods, sps pistons, billet surecam, gt4202r 1.15, 6boost manifold, 60mm gate, 4" exhaust, nizpro plenum, 80mm throttle body, bosch 2000cc injectors, 2x044, -8 fuel line, standard fuel rail modified -8 in-out. c4 box 3000 stall, standard diff with 31 spline axles, full spool.
477rwkw 24psi. 9.80 @ 145mph
User avatar
justa6
Full Boost
 
Posts: 2986
Joined: February 24th, 2008, 2:55 pm
Has Liked: 88 times
Been Liked: 525 times

1999 Ford xr6 ute

Re: G6ET drags

Postby old_mate » October 13th, 2014, 9:35 pm

You would only need a retubed shaft at that level only costs 500 or so. Rest of the driveline should be sweet although you will probably peg a big dirty single leaving with boost unless you have swapped out the unlimited slip diff with something else
G6E Turbo.
User avatar
old_mate
Spooling Up
 
Posts: 894
Joined: July 20th, 2007, 11:34 pm
Has Liked: 5 times
Been Liked: 27 times

Re: G6ET drags

Postby Sunboost » October 13th, 2014, 10:31 pm

Are you Sener's mate?
Edge FG G6ET 50th Anniversary
Vixen BF F6 R-Spec
User avatar
Sunboost
Moderator
Moderator
 
Posts: 6900
Joined: July 13th, 2007, 11:18 am
Has Liked: 98 times
Been Liked: 471 times


Return to Drags, Drift & Track

Who is online

Users browsing this forum: No registered users

cron