Page 1 of 3

ITUF65 4lt mustang once on L.P.G and now on E85

PostPosted: March 6th, 2012, 7:50 pm
by ezy10
Hi guys thought i'd start a thread on my car it's a 65 mustang with an AU turbo running on L.P.G been building this car for a few years now and finished it off about 2 yrs ago
the car has gone a best of 9.20@148 but has run 153mph Jason ghiller and I built the car with all the fabrication done by jason here are some spec's
car makes 600rwkw
au engine
sps pistond
H-beam rods
wade cam and tunnel vision billet rockers
TunnelV plenum and manifold
GTX45r
gas research lpg setup
powerglide tce convertor
9in with truetrac
here are a few vids
http://www.youtube.com/watch?v=siWqyB87LNs
http://www.youtube.com/watch?v=4SO5Rj1_ ... ure=relmfu
ill put somemore pics and a dyno vid up too

Re: ITUF65 4lt mustang on L.P.G

PostPosted: March 6th, 2012, 8:01 pm
by NUT347
Was this setup in an XF once?

I remember seeing an XF with ezy10 plates.

Sick mustang too man.

Re: ITUF65 4lt mustang on L.P.G

PostPosted: March 6th, 2012, 8:02 pm
by ezy10
NUT347 wrote:Was this setup in an XF once?

I remember seeing an XF with ezy10 plates.

Sick mustang too man.


the xf was my old car that had a 250 in it this setup is new and only in this car.

Re: ITUF65 4lt mustang on L.P.G

PostPosted: March 6th, 2012, 8:02 pm
by TUFED6
Mintest car in Aus I reckon. Tho I'm biased cos I like 4L's & Mustangs. :)

Whats next? No project car is ever finished. Tho its hard to see what else you could do with it.

Re: ITUF65 4lt mustang on L.P.G

PostPosted: March 6th, 2012, 8:03 pm
by EBOOST
love this thing.

great job mate.
any plans for 8's or u happy with where it is?
cheers josh

Re: ITUF65 4lt mustang on L.P.G

PostPosted: March 6th, 2012, 8:05 pm
by ezy10
TUFED6 wrote:Mintest car in Aus I reckon. Tho I'm biased cos I like 4L's & Mustangs. :)

Whats next? No project car is ever finished. Tho its hard to see what else you could do with it.


thanks :)
just consentrating on running an 8 for now then i'm sure i'll do something esle to it:)

Re: ITUF65 4lt mustang on L.P.G

PostPosted: March 6th, 2012, 8:16 pm
by pHaT`eL
Love it so so much!
Love it even more cos it hits the hwy aswell!

Re: ITUF65 4lt mustang on L.P.G

PostPosted: March 6th, 2012, 8:18 pm
by ezy10
http://www.youtube.com/watch?v=HGQvITnseYk
here is the dyno video the car ran 148mph with this power but has since run 153mph haven't dynoed it yet but should be making over 600 now
on the moroso with it's wieght and mph it's showing 1050hp at the engine

Re: ITUF65 4lt mustang on L.P.G

PostPosted: March 6th, 2012, 8:20 pm
by sikwags_218
That insane man, well done I love it. Looks tough as and goes very hard. Good job :good:

Cheers Scott :drinks2:

ITUF65 4lt mustang on L.P.G

PostPosted: March 6th, 2012, 8:22 pm
by needfordspeed
Love everything about it! Welcome to the forums.

ITUF65 4lt mustang on L.P.G

PostPosted: March 6th, 2012, 8:25 pm
by wombi90
Tunnel vision do great stuff with LPG!

Re: ITUF65 4lt mustang on L.P.G

PostPosted: March 6th, 2012, 8:29 pm
by justa6
I've followed this on fullboost. Has got a lot of history. It's a massive credit to you, such a flawless build, well done and welcome.

Re: ITUF65 4lt mustang on L.P.G

PostPosted: March 6th, 2012, 8:47 pm
by ezy10
Image
Image
Image

Re: ITUF65 4lt mustang on L.P.G

PostPosted: March 6th, 2012, 9:28 pm
by OED666
bloody awesome car!! love hearing this thing spool and just fark off down the strip!! top job!

Re: ITUF65 4lt mustang on L.P.G

PostPosted: March 7th, 2012, 12:23 am
by iCER
ITUF65 > iCER.

EOF!

Great work John! Still looks as good as ever.
Whats next was asked? A petrol tune lol.


What are your thoughts on the reverse cowl bonnet setup? Is that just for drags or is it on perm now?

Re: ITUF65 4lt mustang on L.P.G

PostPosted: March 7th, 2012, 7:38 am
by EFFalcon
very nice car.
glad you posted it on here :D

Re: ITUF65 4lt mustang on L.P.G

PostPosted: March 7th, 2012, 9:44 am
by ezy10
iCER wrote:ITUF65 > iCER.

EOF!

Great work John! Still looks as good as ever.
Whats next was asked? A petrol tune lol.


What are your thoughts on the reverse cowl bonnet setup? Is that just for drags or is it on perm now?



the reverse cowl is perminate .
Why would i go petrol i dont want to slow the car down :)
i'm considering going vapour inj later on

Re: ITUF65 4lt mustang on L.P.G

PostPosted: March 7th, 2012, 10:00 am
by misk
Love this car, its always been an inspiration to me when working with LPG.

Re: ITUF65 4lt mustang on L.P.G

PostPosted: March 7th, 2012, 10:09 am
by TUFED6
Would be interested if you can share what type of rear suspension you have now. I haven't really been following but I remember reading on fullboost that it had a 4 link but you were going back to leaf springs or something.

Re: ITUF65 4lt mustang on L.P.G

PostPosted: March 7th, 2012, 10:23 am
by ezy10
it used to run a 3link but could only manage a 9.7 with that so i went back to a leaf spring rear end which seems to be working alot better now i aslo tubbed the car while i was at it it runs 10.5slicks and 325 mt radials

Re: ITUF65 4lt mustang on L.P.G

PostPosted: March 7th, 2012, 2:04 pm
by iCER
'oh i also just tubbed the car whilst at it'.


Make it sound like a few hour job no worries lol

Re: ITUF65 4lt mustang on L.P.G

PostPosted: March 7th, 2012, 4:32 pm
by Michael (HYPOEB)
Realy nice car mate! Read abit about it on fullboost.

Re: ITUF65 4lt mustang on L.P.G

PostPosted: March 7th, 2012, 7:20 pm
by ezy10
iCER wrote:'oh i also just tubbed the car whilst at it'.


Make it sound like a few hour job no worries lol


lol it always sounds easy after it's done :D

Re: ITUF65 4lt mustang on L.P.G

PostPosted: March 7th, 2012, 8:29 pm
by ed40
One of my fav cars ever.
Love the idea of old school and new turbo 6.

mustang ran a PB yesterday at heathcote 8.98@154

PostPosted: June 11th, 2012, 1:40 pm
by ezy10
Image

video of the run on this
www.youtube.com/watch?v=_kx6XOKpkpY

Re: ITUF65 4lt mustang on L.P.G

PostPosted: June 11th, 2012, 1:53 pm
by Michael (HYPOEB)
Dosnt really get much better then that for a street car!

Re: ITUF65 4lt mustang on L.P.G

PostPosted: June 11th, 2012, 3:19 pm
by OMY-747
So much win in this car. I love it man, massive props to you for the build. Good to hear the leaf springs are working good. Cause I wanna stick with the leaves in my wagon when that project gets started in a few years :)

Re: ITUF65 4lt mustang on L.P.G

PostPosted: June 11th, 2012, 8:20 pm
by justa6
well done. this car is sooo consistent. a real credit to you and jason..

Re: ITUF65 4lt mustang on L.P.G

PostPosted: June 11th, 2012, 8:40 pm
by EFFalcon
yep, brilliant.

Re: ITUF65 4lt mustang on L.P.G

PostPosted: June 11th, 2012, 9:21 pm
by NUT347
That's insane, well done!

Re: ITUF65 4lt mustang on L.P.G

PostPosted: June 11th, 2012, 10:14 pm
by bng
Crap camera work but **** YEA! Insane is an understatement
Well done

Re: ITUF65 4lt mustang on L.P.G

PostPosted: June 11th, 2012, 10:29 pm
by Zaneyxr6
This car is insane! It doesn't happen to get around Thomastown often does it?

Re: ITUF65 4lt mustang on L.P.G

PostPosted: June 11th, 2012, 10:46 pm
by ezy10
Zaneyxr6 wrote:This car is insane! It doesn't happen to get around Thomastown often does it?




yeah it does all the time:)

Re: ITUF65 4lt mustang on L.P.G

PostPosted: June 15th, 2012, 10:15 pm
by misk
who did you cam dude?
as in who came up with the grind if its custom, or what wade cam is it if its off the shelf?

Re: ITUF65 4lt mustang on L.P.G

PostPosted: June 17th, 2012, 11:06 am
by ezy10
Jason came up with it, it's a custom one.
not an off the shelf?

Re: ITUF65 4lt mustang on L.P.G

PostPosted: June 17th, 2012, 1:05 pm
by misk
all good thought that might be the case :) cheers

Re: ITUF65 4lt mustang on L.P.G

PostPosted: June 18th, 2012, 7:56 pm
by LOW_XR
seen this a few times now and its pretty nice. stands out and has some serious balls to match. something different from the usual v8 route.

Re: ITUF65 4lt mustang on L.P.G

PostPosted: May 1st, 2013, 5:39 pm
by Michael (HYPOEB)
So this has been de stroked now hasn't it? How dose it feel to drive now?

Re: ITUF65 4lt mustang on L.P.G

PostPosted: May 3rd, 2013, 6:08 pm
by pHaT`eL
Pretty sure I saw somewhere its now on E85 aswell..

Re: ITUF65 4lt mustang on L.P.G

PostPosted: May 3rd, 2013, 6:45 pm
by Rollin
Oooooh E85 :clapping: :clapping: :clapping: :clapping:

This thing is gorgeous! Love the cheeky AU sump making an appearance on launch :D