au xr6 ute before turbo. QLD
3 posts
• Page 1 of 1
au xr6 ute before turbo. QLD
by shagin_wagon » August 25th, 2013, 10:29 am
Hi all this is my 99 au xr6 ute its nothing special at all at the moment but has just been taken off the road to mod it and turbo so here is a piss pore burnout before the turbo goes on. http://youtu.be/Od3gLhLJSKQ
-
shagin_wagon - Cranking Over
- Posts: 7
- Joined: February 20th, 2013, 3:41 pm
- Has Liked: 0 time
- Been Liked: 0 time
Re: au xr6 ute before turbo. QLD
by justa6 » August 25th, 2013, 8:42 pm
Welcome bud. One of your first post's and it involves a skid, good stuff.
What are your plans for the turbo setup?
What are your plans for the turbo setup?
manley rods, sps pistons, billet surecam, gt4202r 1.15, 6boost manifold, 60mm gate, 4" exhaust, nizpro plenum, 80mm throttle body, bosch 2000cc injectors, 2x044, -8 fuel line, standard fuel rail modified -8 in-out. c4 box 3000 stall, standard diff with 31 spline axles, full spool.
477rwkw 24psi. 9.80 @ 145mph
-
justa6 - Full Boost
- Posts: 2986
- Joined: February 24th, 2008, 2:55 pm
- Has Liked: 88 times
- Been Liked: 525 times
1999 Ford xr6 ute
Re: au xr6 ute before turbo. QLD
by shagin_wagon » August 27th, 2013, 7:12 pm
just doing the basics for now = turbo ,cam ,valve springs ,porting ,chip ,decomp ,electronic shift kit and shim the slipper for now.
The wheels are off getting blasted and powder coated black then the roll bar and ba xr8 bonnet bulge etc. Want big power later but for now i will be happy with about 220kw at the rear.
The wheels are off getting blasted and powder coated black then the roll bar and ba xr8 bonnet bulge etc. Want big power later but for now i will be happy with about 220kw at the rear.
-
shagin_wagon - Cranking Over
- Posts: 7
- Joined: February 20th, 2013, 3:41 pm
- Has Liked: 0 time
- Been Liked: 0 time
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users