Hi I was wondering if a air intake manifold or an EL will fit on an ED? Also would I have to get a EL fuel rail? Please help as I'm trying to make the engine bay look as good as it runs, and get better air intake.
Cheers
Tidy xr6?
Air intake manifolds
3 posts
• Page 1 of 1
Air intake manifolds
by Tidy xr6 » June 12th, 2014, 8:04 am
- Tidy xr6
- Idling
- Posts: 38
- Joined: May 11th, 2014, 10:38 am
- Has Liked: 1 time
- Been Liked: 0 time
1994 Tickford Ford Falcon XR6
Re: Air intake manifolds
by DJV8T5 » June 12th, 2014, 4:48 pm
BBM will fit on any injected Ford 4.0 I6. Requires supporting mods on boxcars, such as serpentine belt conversion, top thermostat housing, top radiator hose, and I would advise thermofans. Also would require EL ECU and wiring/vacuum lines to suit. Would have to change fuel rail as well, also accelerator pedal and throttle cable, along with cruise cable if your car has it
-
DJV8T5 - Breaking Traction
- Posts: 1805
- Joined: March 2nd, 2011, 9:58 pm
- Location: Wodonga
- Has Liked: 216 times
- Been Liked: 88 times
Re: Air intake manifolds
by Jayedxr6 » June 12th, 2014, 8:25 pm
Can run 3 belt setup by why would you.
Xh falcon turbo. 420rwhp 16 psi.
-
Jayedxr6 - Breaking Traction
- Posts: 1954
- Joined: November 26th, 2011, 6:40 pm
- Has Liked: 179 times
- Been Liked: 149 times
1994 Ford ED Falcon XR6
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users