Boosted Falcon

Better pics

Fresh paint happening first up in the morning

they came up great mate,

Cheers dude can't wait till get them on sick of the ef xrs that are on there now

Yum!

get_an_ea_today wrote:Yum!

Cheers mate

Looks mint mate. Just gotta do the red stripe


Cheers

Yeah man I use this turtle wax stuff on them makes them come back up mint but I haven't really detailed it properly lately because it looked crappy with the ef xrs, but when/if I get it resprayed ill do them aswell I've got a full set of new badges to go on aswell

a couple of better pics In daylight

Mint!!

Cheers nut, body is far from perfect but ill worry about that after I've done the driveline and suspension

And the second defect in 5 months for the same thing too low, he asked about the airbox and wanted to know why I had it haha and asked how i see who much coolant i have and if it's turbo'd didn't pick the wheels but asked if the were of a new ford? didnt get the spacers or exhaust so I think I got off light

Would of been a good photo I reckon green fg xr6t pulling up the green el xr6

Sucks about the canary mate, but your car looks so damned mint with those wheels on it. Hopefully you will get it cleared easy enough. I fail to see how a low car is a danger to other motorists, but you get that.

Only a minor so just lift it up and get it cleared at vic roads

Damn the stock brakes look tiny in there

Yeah I want to get big brakes and change the offset so I don't need spacers

How much too low is it? Looks mint at that height.

20-30mm on exhaust and about 10mm on k frame

It's easy enough to put standard springs in the rear front will be abit more annoying haha

Nah man only on hard bumps under acceleration and that's not even much starts to do it when I get more then 1 person in the back more often though,
Depends what I have the konis set on too

Chasing a front end knock in this thing lately pretty sure its the rack so ill swap that out soon.
Also changed the rear lower control arms, put a new rocker cover gasket, steering intermediate shaft, power steering pump, throttle cable, cruise cable, cruise module, brake pressure switch
That's as I cleared the defect lol
Then I chopped 1 1/2 coils off the stock springs so next time its not so bad haha

staunchxr wrote:ahh well thats alright least yours is good lol. how come you changed the rear control arms? what setting are yours on right up the front or towards the back? going to get new shocks for mine i reckon thats the problem funny i was cutting springs today aswell lol

Just changed the lower one man pretty sure the upper control arm is all the way to the back. Put an aftermarket nolathane lower control arm in meant to be better then stock

Think that's where standard are? Xrs have different control arms I'm lead to believe

Cars looking mint, height looks great. How do you find the ride and handling with the kings cut in the rear?? Does it get a bounce up like cut standard springs or do the konis make up for it?? I wanna chop my SSLs the guard is sitting too far off the FTRs haha

XHBrad wrote:Cars looking mint, height looks great. How do you find the ride and handling with the kings cut in the rear?? Does it get a bounce up like cut standard springs or do the konis make up for it?? I wanna chop my SSLs the guard is sitting too far off the FTRs haha

Thanks mate handles fairly good although I don't push it very hard, no bounce in the rear at all even with the konis set to the softest setting they are still pretty firm it's pretty bouncy ATM with the cut standard springs and shocks In it the cops are still blitzing up here so they are in it because its still over 100mm so I won't get defected again

Cheers for that.. I'll give the springs a trim and wind the konis up a bit and should be sweet..

There is f all cut off the ssl's though maybe 1/4 - 1/2 of a coil

wombi90 wrote:There is f all cut off the ssl's though maybe 1/4 - 1/2 of a coil

OK Cheers for that, ill just cut a little at a time and see how it looks. and hopefully don't get measured up for a while..

Lol I got these springs like this I had another set that weren't cut but sold them

Moved the relays under the guard last night heaps of room in the bay now, will cut the battery tray down tonite
Played around with a photo edit app and thought this looked cool

Heaps of room with everything moved

Only trouble with hiding the wiring on e series is it shows of how goddamn ugly the shock towers are...

Lol yeah they aren't the best looking tower but I'd prefer the tower then messy wires and old yellow coolant reservoir

Cut the bracket out and made up a bracket to secure the battery

Looks the goods without the batery tray backing man

So I sold this and brought an 02 au ute ute's more practical for me ATM here she is it's an opt 20 (ex cop) has 406,xxxks but reco motor and box,has an lsd, interior is clean as 3 seater column auto, passenger airbag, came lowered but ill be putting standard suspension back in, probably put some 16" stockies on it aswell, has 5 months rego, standard tail lights will be in it aswell, drives so much smoother then then the el too. Will be converting it to LPG aswell

Looks nice. What are you planning on doing with it? It sits real nice and looks smick on those wheels.

Nothing man just want to use it as a daily and I want to save for a f6 so this is practical if I want to wreck more cars or buy a few repairable write offs and fix and I can tow my boat and take it to the river